Siemens Industry Online Support - Automation Service, Automation Support, Simatic Service, Simatic Support, Technical Support, Technical Consulting

FM 353, 354, 453 -- Setting up and parameterizing hardware -- Initializing and parameterizing modules

	What must be considered when using the SIMATIC S7 FM354 module with incremental encoder?
	What should you watch out for when calling FB POS_CTRL and FB POS_MSRM?
	Which function modules (FM) can be used remotely in an ET 200M?
	What should you watch out for when parameterizing a digital input for the "Set flying actual value" function in Automatic mode?
	How do you assign parameters to an FM354 when using an absolute linear rule?
	What does MD38 signify with FM 353?
	How can you reduce the positioning times for short distances?
	What invokes the procedure program error 0x0801 "Program selection subprogram error"?
	How many FM 353s or FM 354s can the communicate with an OP that is connected to the CPU via MPI?
	Transferring an NC block (traversing program) by user program to an FM353 / FM354
	Aborting an active MDI record of an FM353 or FM354
	Behavior of the FM 354 upon signal change at the release input

What must be considered when using the SIMATIC S7 FM354 module with incremental encoder?

Part number:

Description
When using an incremental encoder the resolution of the encoder must not exceed 8000 steps/rotation. If the resolution is exceeded (10,000 steps/rotation, for example), then the zero mark monitoring function can no longer be executed correctly.

Entry ID:51930734

Date:2011-08-31

I regard this article....

as helpful

as not helpful

Copy link

Suggestion for the entry

Send to a friend