Siemens Industry Online Support - Automation Service, Automation Support, Simatic Service, Simatic Support, Technical Support, Technical Consulting

S7-300 CPU 31x -- Product information -- Technical data

	How can you control the ALM (Active Line Module) of a CU320 (with DriveCLIQ) with the SIMATIC program?
	Where can you find an update to use the SINAMICS with newer firmware in S7 Technology V4.1?
	Which modules can you use when implementing software redundancy?
	Which organization blocks do you have to load into the CPU to ensure that the CPU does not go into the "STOP" status when a remote I/O fails?
	How do you find out further technical information about your module?
	Why can't I see the values which are transmitted to an unlinked destination DB with SFC84, even though SFC84 is not indicating an error (RET_VAL = W#16#000?
	How does the CPU 31x/31xC/C7 react when an MMC fault occurs during the save procedure?
	What is the effect of the STEP 7 function "Copy RAM to ROM"?
	Why does the SFC 54 "RD_DPARM" not work with the new S7-300 CPU with MMC?
	How do you copy the user program from the load memory into the main memory without PG with a S7-300 CPU with MC slot?
	How can you backup your program from the load memory?
	Which communication services supported by the CPUs with integrated PROFINET interface and by the WinAC RTX via Industrial Ethernet?
	Implementation of SIMATIC modules of the product families S7-300, S7-400, ET 200M, ET 200S ET, 200iSP and TDC in environments with high concentrations of corrosive gas
	At which ambient temperature and at which air pressure can you operate a SIMATIC S7-300?
	What can you do when the power requirement of the modules in the subrack exceeds the power supply provided by the CPU on the backplane bus?
	Where do you find certificates and approvals for SIMATIC S7 in the Internet?
	Where can you find images, graphics, symbols and screenshots for SIMATIC industrial automation systems?
	Which SIMATIC S7 components and which drives support clock-synchronicity functionality?

How can you control the ALM (Active Line Module) of a CU320 (with DriveCLIQ) with the SIMATIC program?

Part number:

Description
Using FB390 "ALM_Control" you can control an ALM (Active Line Module) with DriveCLIQ of a SINAMICS 120S in combination with a SIMATIC CPU.
See below for the block (for STEP 7 V5) and instructions for commissioning the block:

49515414_ALM_Control_SIMATIC_en.pdf ( 731 KB )

49515414_ALM_Control_SIMATIC.zip ( 850 KB )

Entry ID:49515414

Date:2012-06-14

I regard this article....

as helpful

as not helpful

Copy link

Suggestion for the entry

Send to a friend